|
|||||||||||||||||||||||||||||||||
|
|||||||||||||||||||||||||||||||||
This article is about the SI derived unit. For the Chevrolet car, see Chevrolet Volt. For the Toyota car, see Toyota Alessandro Volta. For the French-language Canadian television series, see Volt (TV series). For the AC/DC album, see Volts (album).
Josephson junction array chip developed by NIST as a standard volt.
The volt (symbol: V) is the SI derived unit of electric potential difference or electromotive force, commonly known as voltage.12 It is named in honor of the Lombard physicist Alessandro Volta (1745–1827), who invented the voltaic pile, the first chemical battery.
DefinitionThe volt is defined as the potential difference across a conductor when a current of one ampere dissipates one watt of power.3 Hence, it is the base SI representation m2 · kg · s-3 · A-1, which can be equally represented as one joule of energy per coulomb of charge, J/C. Josephson junction definitionSince 1990 the volt has been maintained internationally for practical measurement using the Josephson effect, where a conventional value is used for the Josephson constant, fixed by the 18th General Conference on Weights and Measures as
Hydraulic analogyIn the hydraulic analogy sometimes used to explain electric circuits by comparing them to water-filled pipes, voltage is likened to water pressure – it determines how fast the electrons will travel through the circuit. Current (in amperes), in the same analogy, is a measure of the volume of water that flows past a given point per unit time (volumetric flow rate). The flow rate is determined by the width of the pipe (analogous to electrical resistance) and the pressure difference between the front end of the pipe and the exit (potential difference or voltage). The analogy extends to power dissipation: the power given up by the water flow is equal to flow rate times pressure, just as the power dissipated in a resistor is equal to current times the voltage drop across the resistor (amperes x volts = watts). The relationship between voltage and current (in ohmic devices) is defined by Ohm's Law. Common voltages
A multimeter can be used to measure the voltage between two points
Nominal voltages of familiar sources:
Note: Where 'RMS' (root mean square) is stated above, the peak voltage is History of the voltIn 1800, as the result of a professional disagreement over the galvanic response advocated by Luigi Galvani, Alessandro Volta developed the so-called Voltaic pile, a forerunner of the battery, which produced a steady electric current. Volta had determined that the most effective pair of dissimilar metals to produce electricity was zinc and silver. In the 1880s, the International Electrical Congress, now the International Electrotechnical Commission (IEC), approved the volt for electromotive force. At that time, the volt was defined as the potential difference across a conductor when a current of one ampere dissipates one watt of power. The international volt was defined in 1893 as 1/1.434 of the emf of a Clark cell. This definition was abandoned in 1908 in favor of a definition based on the international ohm and international ampere until the entire set of "reproducible units" was abandoned in 1948. Prior to the development of the Josephson junction voltage standard, the volt was maintained in national laboratories using specially constructed batteries called standard cells. The United States used a design called the Weston cell from 1905 to 1972.
See alsoReferences
External links |
| firanki • zasłony • www.autostrada.powiadaj.pl • długi szalik • Zabytki • Grzyby • Grzyby • Grzyby • Grzyby • Grzyby • Grzyby • Grzyby • Grzyby • Hotele • Hotele All Right Reserved © 2007, Designed by Stylish Blog. |